Xerox XK25C User Manual

Getting Started

11

The WorkCentre is a dual cartridge inkjet printer.  You must use a black ink
cartridge and a color ink cartridge.  When viewed from the front of the
machine, the color ink cartridge is installed in the left cartridge holder and the
black ink cartridge is installed in the right cartridge holder. Use the following
procedure to install the two ink cartridges and align them.

When installing ink cartridges, you must provide specific information to the
WorkCentre about the cartridges you install. This allows the printer to monitor
ink cartridge utilization.

There are two methods of entering cartridge information.

Q

Using the WorkCentre Control Panel buttons

Q

Using the WorkCentre Control Program software and a PC

The procedures in this section describe ink cartridge installation without
using the WorkCentre Control Program. To install ink cartridges using the
WorkCentre Control Program, see Section 

5 Maintenance/Control Program.

1

Load sheets of paper (A4) into the Automatic
Paper Feeder against the right edge of the
paper feeder. Squeeze the side paper guide
with two fingers to release the guide, and slide
the guide all the way to the left side of the paper
tray.

Ensure that the guide is against the left edge of
the paper. For best results, use high quality xerographic copy paper or
inkjet paper.

2

Open the entire scanner module (not just the document cover) by lifting
the front edge upwards.

3

Support the scanner module by lifting the cartridge compartment
lid/support up so the scanner module rests on the top edge of the
lid/support.

4

Press the Menu button. A 

 message will appear in the Display.

Press Start. The cartridge holder will move left to the open change area.
The 

 message (left cartridge) will appear.

ª