Xerox 75 User Manual

Page of 76
Safety notes
Operator Guide
2-12
DocuTech/DocuPrint 75/90 and DocuPrint 75 MX
Printer or controller - emergency power off
If any of the following conditions occur, turn off the equipment 
immediately and disconnect the power cable from the electrical 
outlet. Contact an authorized Xerox Service Representative to 
correct the problem:
The equipment emits unusual odors, or makes unusual 
noises.
The power cable is damaged or frayed.
A wall panel circuit breaker, fuse, or other safety device has 
been tripped.
Liquid is spilled into the equipment.
The equipment is exposed to water damage or flood.
Any part of the equipment is physically damaged.
NOTE:   The only method to remove all power from the printer is 
to disconnect the power cable from the electrical outlet. 
Printer - ozone information
This product produces ozone during normal operation. The 
ozone produced is dependent on print volume and is heavier 
than air. Install the system in a well ventilated room with the 
minimum cubic size requirements listed below. Providing the 
correct environmental parameters will ensure that the 
concentration levels meet safe limits.
The minimum cubic volume requirement is: 1,765 cubic feet (50 
cubic meters).
To determine if the room has the required volume to meet the 
ozone requirement, the length of the room multiplied by its width 
and height should be equal to or greater than the cubic volume 
listed above. 
If you need additional information about ozone, please request 
the Xerox publication Ozone (part number 610P64653) by calling 
1-800-828-6571 in the United States and Canada. In Xerox 
Europe countries and DMO, call the local welcome centre.