Xerox 75 User Manual
Operator Guide
Paper and other stock
DocuTech/DocuPrint 75/90 and DocuPrint 75 MX
5-3
Tray 6
The High Capacity Tray has a capability of only 8.5 x 11 inch
(216 to 279 mm) or A4 long-edge feed (LEF), between 16-32 lb
(75-120 gsm).
(216 to 279 mm) or A4 long-edge feed (LEF), between 16-32 lb
(75-120 gsm).
Trays 1-4
Have a capability of 8 to 17 inches (203 to 432 mm); 5.25 to 11
inches (133 to 279 mm). Call the Welcome Center if you want to
permanently set any of the Trays 1-4 to process 12 x 18 inch
(305 x 457 mm) stock.
inches (133 to 279 mm). Call the Welcome Center if you want to
permanently set any of the Trays 1-4 to process 12 x 18 inch
(305 x 457 mm) stock.
General stapling guidelines
To ensure that stapling of thin sets is satisfactory, finishers that
are produced after 1998 will cycle down after 30 sets of up to 15
sheets or less. You must empty the stacker in order to resume
printing.
are produced after 1998 will cycle down after 30 sets of up to 15
sheets or less. You must empty the stacker in order to resume
printing.
If these parameters are not satisfactory for your printing, please
contact Xerox.
contact Xerox.
Dimensions that can be stapled: The minimum size for
stapling is 6.7 by 8 inches (170 x 203 mm). The fed edge must
be between 8 to 12 inches (203 x 305 mm) to be stapled.
stapling is 6.7 by 8 inches (170 x 203 mm). The fed edge must
be between 8 to 12 inches (203 x 305 mm) to be stapled.
Figure 5-3. Size requirements for stapling
Weights that can be stapled: The Finisher can staple a
maximum of 50 sheets of 20 lb paper. The maximum staple
capability for other stock weights is shown in
maximum of 50 sheets of 20 lb paper. The maximum staple
capability for other stock weights is shown in
This edge
must be
between 8 to
12 inches (203
to 305 mm) to
be stapled.
must be
between 8 to
12 inches (203
to 305 mm) to
be stapled.
Feed
Direction
Direction
Table 5-1. Staple capability for various paper weights
Weight
Maximum Number of Stapled Sheets
20 lb 75 gsm
50
24 lb or 90 gsm
44