Xerox 430 User Manual
Page 13-2
Xerox Document Centre 440/432/430/426/425/420 User Guide
Fault Clearance Procedure
If a fault or problem occurs, there are several ways in which the
type of fault can be identified. Once a fault or problem is
identified, establish the probable cause and apply the
appropriate solution.
type of fault can be identified. Once a fault or problem is
identified, establish the probable cause and apply the
appropriate solution.
- If a fault occurs, refer to the screen messages and
animated graphics and clear the fault in the order
specified.
specified.
- If the problem is not solved by following the screen
messages and graphics, refer to the problem solving
tables on the following pages and apply the appropriate
solution as described.
tables on the following pages and apply the appropriate
solution as described.
- Also refer to the faults codes displayed in the Print Queue
or Faults List in the Machine Status mode. Refer to page
13-16 for an explanation of some of the fault codes and
corresponding corrective actions.
13-16 for an explanation of some of the fault codes and
corresponding corrective actions.
- Alternatively, contact the DC440/432/430/426/425/420
Key Operator for assistance.
- Or switch the machine off and then on again. Ensure that
you follow the relevant power On/Off instructions as
described in Chapter 2 of this user guide.
described in Chapter 2 of this user guide.
CAUTION: Failure to leave at least 20 seconds between
repeated power OFF /ON can result in damage to the
DC440/432/430/426/425/420 hard drive.
repeated power OFF /ON can result in damage to the
DC440/432/430/426/425/420 hard drive.
- If the problem persists, or a message indicates that you
should call for service, please refer to the “Call for Service
procedure” on page13-20.
procedure” on page13-20.
NOTE: If Fax is enabled and a loss of power occurs, the
DC440/432/430/426/425/420 will print a Power Off Report
when the machine is switched on. This will show a list of the
fax jobs lost during the power loss.
DC440/432/430/426/425/420 will print a Power Off Report
when the machine is switched on. This will show a list of the
fax jobs lost during the power loss.