Xerox M118 User Manual

The machine is designed to use a variety of paper types and other media. This chapter 
provides information about loading paper and other types of media into the machine.

This section provides information on how to load paper into trays.
NOTE: Make sure the side and rear paper guides on the trays are properly positioned 
to match the size of paper loaded. If there is a gap between the paper stack and the 
guides, paper may not be fed to the machine properly, or paper jams may occur.

For information on configurable paper sizes and media types for each tray, refer to 
Supported Paper Sizes on page 73 and Supported Paper Types on page 75.
For information on the acceptable range of paper sizes and capacity for each tray, refer 
to Paper Supply in the Specifications chapter on User Guide.

Before loading paper into the paper trays, fan the edges. This procedure separates any 
sheets of paper that are stuck together and reduces the possibility of paper jams.
NOTE: To avoid paper jams and misfeeds, do not remove paper from its packaging 
until required.

Depending on the machine configuration, up to four paper trays will be available 
excluding Tray 5 (bypass tray).
NOTE: If the machine is processing a job, do not open the active paper tray.

Pull out the paper tray towards you.