Xerox 480 ST User Manual
Xerox Document Centre System Administration Guide
Page 11 - 1
11
. M
icr
os
o
ft
Windows
NT
4.X
11.
Mi
c
roso
ft
Wi
ndow
s
N
T
4.
X Serv
er N
e
tw
ork
11. Microsoft Windows NT 4.X Server
Network (TCP/IP)
Network (TCP/IP)
Before you Start
NOTE
Your Document Centre has DHCP enabled by default. If you have
configured a DHCP server with TCP/IP information, you can
connect your Document Centre to your network and it will retrieve
its TCP/IP information from the DHCP server when it is turned on.
configured a DHCP server with TCP/IP information, you can
connect your Document Centre to your network and it will retrieve
its TCP/IP information from the DHCP server when it is turned on.
To enable 100BaseT or a Token Ring interface, refer to Chapter 2
How to Connect to Ethernet or Token Ring Networks to
configure the Speed and Source Routing settings for your
environment.
How to Connect to Ethernet or Token Ring Networks to
configure the Speed and Source Routing settings for your
environment.
If you are using DHCP, perform Steps 1 through 8b contained
within the Dynamic Addressing portion of the Dynamic/Status IP
Address Assignment & WINS section but DO NOT change any
values. Then read the note before step 9 and determine if you wish
to change the lpr port number. After choosing, complete the
remainder of the procedure.
within the Dynamic Addressing portion of the Dynamic/Status IP
Address Assignment & WINS section but DO NOT change any
values. Then read the note before step 9 and determine if you wish
to change the lpr port number. After choosing, complete the
remainder of the procedure.