Toshiba 5520c User Manual

 

e-STUDIO5520C/6520C/6530C 

© 2008 TOSHIBA TEC CORPORATION All rights reserved 

2-10 

 

(4)  Enter the adjustment mode [05] and adjust the gamma balance in each of medium- and high-density areas. 

 

Text/Photo 05-590 

Text 05-591 

Photo 05-592 

ACS / Black 

Text/Photo 

05-7957 

ACS / Black 

Text 

05-7958 

ACS / Black 

Photo 

05-7959 

1/2 

Set a value larger 

than 128. 

0 to 255 

128 

 

1 Medium-density 

area 

2 High-density 

area 

 

* Set the value in increments of approximately 20, while checking the copy image until the optimum value is 

obtained. Note that gradations (density level) in the medium- and high-density areas may be reversed with 

some setting values.  

 

* Subcodes to be entered differ depending on the target density area. Refer to the table above to enter the 

subcode for the area to be adjusted. The density of thin text or illustrations is changed by adjusting mainly 

the setting value for the medium- or high-density area. Do not change the setting value for the low-density 

area because if the subcode is set at "0", the density of the low-density area is adjusted but there is little or 

no effect on changing the density of thin text or illustrations. 

 

 

After changing the value, make a copy and check the image quality. 

If further image quality adjustments are necessary, reset all the values changed in steps (1) to (4) above to 

the default one and then follow the next step.