Toshiba 6520c User Manual

 

e-STUDIO5520C/6520C/6530C 

© 2008 TOSHIBA TEC CORPORATION All rights reserved 

2-34 

 
(5) Enter adjustment mode [05]. Change the values for codes [590] to [592] to adjust the gamma balance in each 

of the low- and medium-density area. 

Text/Photo 05-590  0/1 

Text 05-591 

0/1 

Photo 05-592 0/1 

Set a value smaller than 

128. 

0 to 255 

128 

* Set the value in increments of approximately 20, while checking the copy image until the optimum value 

is obtained. (Note that gradations (density level) in the medium- and high-density areas may be reversed 

with some setting values.) 

 
* Since the subcode varies according to the area where the density is adjusted, refer to the table below and 

set the appropriate subcode.  Remember that mainly adjusting the low- or medium-density area will change 

the copy density of the images seen through the back of the page.   Setting "2" for the subcode will allow 

you to adjust the high-density area.  But this will not solve the problem.  Therefore, never change the value 

for the high-density area. 

0  Low-density 

area 

1  Medium-density 

area 

 

 

‰

The adjustment may possibly cause text handwritten with a pencil or light text to become illegible on the copy.  

Therefore, carefully perform the adjustment, while checking the copy image. 

 

 

‰

Enter a value within the recommended value range mentioned in the procedures.  Otherwise, it may cause a loss 

in MFP performance, including degradation in the image quality and a reduction in the life of the consumables.