Xerox 7345 User Manual
35
Microsoft (NetBIOS over IP) Networks
Before You Start
1.
Print a Configuration Report as stated in the Network Connectivity section of this guide.
2.
Referring to the report, verify that SMB is enabled. To enable SMB at the Device, if required, follow
the procedure below.
the procedure below.
3.
Referring to the Configuration Report, verify that DNS is enabled. The use of Naming Servers is
REQUIRED to resolve NetBIOS device names to IP addresses for packet routing over the TCP/IP
network.
REQUIRED to resolve NetBIOS device names to IP addresses for packet routing over the TCP/IP
network.
4.
To enable the Device to communicate with the Naming Servers, refer to the instructions supplied in the
topic "TCP/IP Dynamic Addressing", located in the NOS Selection section of this guide.
topic "TCP/IP Dynamic Addressing", located in the NOS Selection section of this guide.
5.
When using WINS or DNS, be sure to refer to your Server Operating System documentation for the
appropriate procedure to use to enable NetBIOS name to IP address resolution on the Server.
appropriate procedure to use to enable NetBIOS name to IP address resolution on the Server.
Enabling the SMB Setting at the Device, if required
1.
Press the Log In / Out button on the Control Panel.
2.
Press the "1" key on the numeric keypad five consecutive times. (This is the factory default
"password.")
"password.")
3.
Press Enter on the touch screen.
4.
Press the Machine Status button on the Control Panel.
5.
Press the Tools tab.
6.
Press Connectivity & Network Setup.