Toshiba e Studio45/35 User Manual

 

This chapter describes installing software and setting up printing from a 
Windows-based computer running Windows 95/98/Me, Windows NT 4.0, 
or Windows 2000.

The general steps for installing the software are: 

• Install the PostScript printer driver or PCL printer driver and corresponding 

printer driver files.

• Set up the printer driver to communicate with the GA-1040.

• Install the Command WorkStation software on the designated Windows 95/98/Me, 

Windows NT 4.0, or Windows 2000 workstation(s).

• Configure the connection for Fiery Link and the Command WorkStation.

• Setup IPP printing for Windows 2000.

• Copy additional files from the User Software CD as needed.

 

To set up the GA-1040 as a PostScript or PCL printer, you must install the PostScript 
or PCL printer drivers for Windows 95/98/Me and the corresponding printer 
description files. You can also install the Agfa Monotype Font Manager. Afterwards, 
you configure the particular type of print connection between the workstation and the 
GA-1040. 

 

Using the PostScript driver requires either the HDD option or the PostScript 

option installed on the copier.

The following procedure describes using the User Software CD to install the GA-1040 
as a local (LPT1) printer. The procedures after that describe completing the print 
connection for a network printer.