Zebra Technologies 11680100201 User Manual

Configuration
Setup Mode

P1009874-002

Xi4™/RXi4™ User Guide

1/7/10

After you have installed the media and ribbon and the Power-On Self Test (POST) is complete, 
the control panel displays 

PRINTER READY

. You may now set printer parameters for your 

application using the control panel display and the buttons directly below it. If it becomes 
necessary to restore the initial printer defaults, see 

.

Use the LCD on the control panel to view and adjust printer settings through Setup mode. 
When a parameter is changed, an asterisk (*) appears in the upper left corner of the display to 
indicate that the value is different from the one currently active in the printer.

Certain printing conditions may require that you adjust printing parameters, 

such as print speed, darkness, or print mode. These conditions include (but are not 
limited to):

• printing at high speeds

• peeling the media

• the use of extremely thin, small, synthetic, or coated labels

Because these and other factors affect print quality, run tests to determine the best 
combination of printer settings and media for your application. A poor match may limit print 
quality or print rate, or the printer may not function properly in the desired print mode.

 If the printer is operating on an IP network and you have a ZebraNet 10/100 Print 

Server or Wireless Plus Print Server, you can change the printer’s parameters in these 
additional ways:

• with ZebraLink™ WebView. For information, see the appropriate print server user guide.

• with ZebraNet Bridge. For information, see the ZebraNet Bridge Enterprise Printer 

Management User Guide.

SETUP/EXIT

 

enter or exit Setup mode.

SELECT

select or deselect a parameter.

PLUS (+)

continue to the next parameter.

MINUS (-)

return to the previous parameter in the cycle.