Toshiba 2830C User Manual

Printing from an Application    131

‰

The booklet mode page layout can be selected using the following options.

If left2right=off then long edge binding is selected, otherwise if left2right=on then short edge binding is used.
Example: The command to select left to right page layout for booklet printing mode is 
“lp -o left2right=on filename”.

‰

The booklet mode center margin can be selected using the following options.

Example: The command to select the center margin value for booklet printing mode is 
“lp -o centermargin=value filename”.

left2right=off

OFF

Select right to left page layout for the booklet printing 
mode.
This value decides the layout of the pages in the 
booklet.
If this value is OFF then the layout of pages is Right to 
Left as shown in the figure below.

left2right=on

ON

Select left to right page layout for the booklet printing 
mode.
This is the default setting.
If the value is ON then the layout of the pages is from 
Left to Right as shown in the figure below.

centermargin
=value

Select the center margin value for the booklet printing 
mode.
This value specifies in pixels the Center Margin or the 
“Gutter”. This is in addition to the center margin already 
specified by the application. The valid range for value is 
0 - 300. Default is 0.