Epson NX100 User Manual
Epson Stylus
®
NX100 Series
Start Here
6
Release the scanner support and lower the scanner.
7
Press
the
Stop button to charge the ink. Charging takes about
2 minutes.
Caution: Don’t turn off the NX100 Series while it is charging or you’ll
waste ink.
waste ink.
Unpack
If anything is missing, contact Epson as described on the back.
Caution: Do not open the ink cartridge package until you are ready to install
the ink. Cartridges are vacuum packed to maintain reliability.
the ink. Cartridges are vacuum packed to maintain reliability.
Canada only: For French speakers, remove stickers from the backing sheet
and place over corresponding text on the control panel.
and place over corresponding text on the control panel.
Remove all the tape.
1
Stop
3
Flip the feeder guard forward. Then squeeze the edge guide and
slide it left.
slide it left.
4
Load paper against the right edge and underneath the tab, then slide
the edge guide over.
the edge guide over.
Note: Don’t load the paper sideways.
5
Flip the feeder guard back.
4114365 Rev.0
1-F
1-F
C
4114365 Rev.0
1-F
1-F
M
4114365 Rev.0
1-F
1-F
Y
4114365 Rev.0
1-F
1-F
K
Turn on the NX100 Series
1
Connect the power cable.
Note: Do not connect to the computer at this time.
2
Press
the
On button.
Load paper
1
Open the paper support.
2
Open the output tray and pull out the extension.
4
2
8½ 11
4 6
Install cartridges
Note: Do not load paper yet.
1
Lift up the scanner and prop it up with the support.
2
Shake the ink cartridges, then unpack them.
3
Remove only the yellow tape from each cartridge.
Caution: Do not remove any other seals or the cartridge may leak.
4
Insert the cartridges in the holder for each color.
5
Press each cartridge down until it clicks.
3
(Included for Canada only)