Epson 435 User Manual
32
Notices
Notices
Important Safety Instructions
Before using your Epson product, read and follow these safety instructions:
■
Be sure to follow all warnings and instructions marked on your Epson printer.
■
Use only the type of power source indicated on the printer label.
■
Use only the power cord that comes with the printer. Use of another cord may cause fires or
shock. Do not use the cord with any other equipment.
shock. Do not use the cord with any other equipment.
■
Place the printer near a wall outlet where the plug can be easily unplugged.
■
If you won’t be using the printer for a long period, unplug the power cord from the electrical
outlet.
outlet.
■
Always turn off the printer using the
P
On
button, and wait until the
P
On
light stops
flashing before unplugging the printer or cutting off power to the electrical outlet.
■
Avoid plugging the printer into an outlet on the same circuit as a photo copier or air control
system that regularly switches on and off, or on an outlet controlled by a wall switch or timer.
system that regularly switches on and off, or on an outlet controlled by a wall switch or timer.
■
Do not let the power cord become damaged or frayed.
■
If you use an extension cord with the printer, make sure the total ampere rating of the devices
plugged into the extension cord does not exceed the cord’s ampere rating. Also, make sure the
total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet’s
ampere rating.
plugged into the extension cord does not exceed the cord’s ampere rating. Also, make sure the
total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet’s
ampere rating.
■
Avoid locations that are subject to rapid changes in heat or humidity, shocks or vibrations, or
dust.
dust.
■
Leave enough room around the printer for sufficient ventilation. Do not block or cover
openings in the case or insert objects through the slots.
openings in the case or insert objects through the slots.
■
Do not place the printer near a radiator or heating vent or in direct sunlight.
■
Place the printer on a flat, stable surface that extends beyond its base in all directions. It will not
operate properly if it is tilted or at an angle.
operate properly if it is tilted or at an angle.
■
Make sure the back of the printer is at least 4 inches (10 cm) away from the wall.
■
Do not open the scanner section while the product is copying, printing, or scanning.
■
Do not spill liquid on the printer.
■
Except as specifically explained in your documentation, do not attempt to service the printer
yourself.
yourself.
■
Unplug the printer and refer servicing to qualified service personnel under the following
conditions: if the power cord or plug is damaged; if liquid has entered the product; if the
product has been dropped or the case damaged; if the product does not operate normally or
exhibits a distinct change in performance. Adjust only those controls that are covered by the
operating instructions.
conditions: if the power cord or plug is damaged; if liquid has entered the product; if the
product has been dropped or the case damaged; if the product does not operate normally or
exhibits a distinct change in performance. Adjust only those controls that are covered by the
operating instructions.
andes_p2_QG.book Page 32 Wednesday, May 25, 2011 3:39 PM