Advantech FPM-3150 Series User Manual
FPM-3150 Series User Manual
34
Appendix B Standard Timing Set Serial
Data for Expansion
B.1 Setting serial data for expansion
The twelve kinds of timings below are already programmed in this mod-
ule. The input synchronous signals are automatically recognized.
ule. The input synchronous signals are automatically recognized.
Resolution
Vertical Frequencies
56 Hz
56 Hz
60 Hz
70 Hz
72 Hz
75 Hz
Pass
Fail
Pass
Fail
Pass
Fail
Pass
Fail
Pass
Fail
640 x 480
V
V
V
800 x 600
V
V
V
V
V
1024 x 768
V
V
V
V
Note 1:
Even if the preset timing is entered, a little
adjustment of the functions such as Horizontal
period, CLK-delay and display position, are
required. The adjusted values are memorized in
every preset number.
adjustment of the functions such as Horizontal
period, CLK-delay and display position, are
required. The adjusted values are memorized in
every preset number.
Note 2:
This module recognizes the synchronous signals
with near preset timing of the frequency of the
HS and Vsync, even in the case that the signals
other than the preset timing that were entered.
with near preset timing of the frequency of the
HS and Vsync, even in the case that the signals
other than the preset timing that were entered.
Note 3:
Because adjustments may not fit, such as
differing magnifying ratios or, in the case that you
use it except for the display timing that was pre-
set.
differing magnifying ratios or, in the case that you
use it except for the display timing that was pre-
set.