AG Neovo 1000 User Manual

C H A P T E R

If you are experiencing trouble with your touchmonitor, refer to the following table. If the problem

persists, please contact your local dealer or our service center.

The monitor does not respond

Check that the monitor’s Power Switch is on.

after you turn on the system

Turn off the power and check the monitor’s power cord

and signal cable for proper connection.

Characters on the screen are dim

Refer to the About Touchmonitor Adjustments section to

adjust the brightness.

The screen is blank

During operation, the monitor screen may automatically turn

off as a result of the Power Saving feature. Press any key to see

if the screen reappears.

Refer to the About Touchmonitor Adjustments section to

adjust the brightness.

Screen flashes when initialized

Turn the monitor off then turn it on again.

“Out of Range” display

Check to see if the resolution of your computer is higher than

that of the LCD display.

Reconfigure the resolution of your computer to make it less

than or equal to 1024x768. See Appendix A for more information

on resolution.

Touch doesn’t work

Make sure the touch cable is securely attached at both ends.

4-23