Sharp PN-A601 User Manual

44

E

When the PN-ZB01 (optional) is attached, your monitor can

be connected to a LAN allowing you to control it from a PC on

the LAN. 

You can also configure the monitor to send e-mail notification

when it has a problem. 

The connection requires a commercially available LAN cable

(UTP cable, Category 5, straight through).

Hub 

LAN terminal 

LAN cable (commercially available, straight) 

Network (LAN) 

TIPS

•  You must assign an IP address to the monitor by following

the procedures in “Settings to connect to a LAN”. (See the 

description on the right.)

•  Your PC must be installed with Internet Explorer (version 7.0

or later). 

•  To control the monitor via LAN, set RS-232C/LAN SELECT

to LAN. (See page 24.)

•  You cannot use RS-232C and LAN control simultaneously.

•  When the PN-ZB01 (optional) is attached, personal

information such as e-mail addresses can be registered in

the monitor. Before transferring or disposing of the monitor,

initialize all settings by selecting ALL RESET 1. (See

page 30.) Note that ALL RESET 2 will not initialize e-mail

addresses and other settings.

Set the monitor’s IP address and subnet mask to match the 

settings of your LAN. 

These settings can be made on either the monitor or a PC

connected to the monitor.

The settings depend on the configuration of your LAN. Ask

your LAN administrator for details. 

Set RS-232C/LAN SELECT on the SETUP menu to LAN, and

then set the LAN SETUP options. (See page 24.)
After setting each item, select SET and press

MENU

.

DHCP CLIENT
If your LAN has a DHCP server and you wish to obtain an

address automatically, change this setting to ON. 

To set the address manually, set this to OFF.
IP ADDRESS
If the DHCP CLIENT is set to OFF, specify an IP address.
Press 

 or 

  to select items, and press 

 or 

 to 

change the values.
SUBNET MASK
If the DHCP CLIENT is set to OFF, specify the subnet mask.
Press 

 or 

  to select items, and press 

 or 

 to 

change the values.
DEFAULT GATEWAY
If the DHCP CLIENT is set to OFF, specify the default

gateway. 

If you are not using a gateway, specify “0.0.0.0”.
Press 

 or 

  to select items, and press 

 or 

 to 

change the values.
RESET
Resets the values of the LAN settings to the factory preset 

values. 
Select ON and then press 

MENU

.

TIPS

•  When the IP address is set manually, the IP addresses of

the monitor connected to the RS-232C output terminal and

the daisy chain of connected monitors that follows can be 

assigned automatically. (See page 24.)