Sony SDM-S51R User Manual

Troubleshooting

Before contacting technical support, refer to this section.

On-screen messages

If there is something wrong with the input signal, one of the
following messages appears on the screen. To solve the problem,
see “Trouble symptoms and remedies” on page 18.

If OUT OF SCAN RANGE appears on the screen

This indicates that the input signal is not supported by the
monitor’s specifications. Check the following items.

If “xx.x kHz/xx Hz” is displayed

This indicates that either the horizontal or vertical frequency
is not supported by the monitor’s specifications.
The figures indicate the horizontal and vertical frequencies of
the current input signal.

If “RESOLUTION > XGA” is displayed (SDM-S51R)

This indicates that the resolution is not supported by the
monitor’s specifications.

If “RESOLUTION > SXGA” is displayed (SDM-S71R/
S81R)

This indicates that the resolution is not supported by the
monitor’s specifications.

If NO INPUT SIGNAL appears on the screen

This indicates that no signal is input.

GO TO POWER SAVE

The monitor will enter the power saving mode after about 5
seconds from the message is displayed.

If CABLE DISCONNECTED appears on the screen

This indicates that the video signal cable has been disconnected
from the currently selected connector.

GO TO POWER SAVE

The monitor will enter the power saving mode after about 5
seconds from the message is displayed.

OUT OF SCAN RANGE

x x . x k H z /

x x H z

I NFORMA T I ON

I NPUT S I GNA L

GO TO POWER SAVE

I NFORMA T I ON

CAB L E D I SCONNECT ED

GO TO POWER SAVE

I NFORMA T I ON