Sony SDM-X75 User Manual

11

p y

AEP.fm

• Check that the power cord and the video signal cables are 

properly connected.

• If “NO INPUT SIGNAL” appears on the screen:
– The computer is in the power saving mode. Try pressing any 

key on the keyboard or moving the mouse.

– Check that the input signal setting is correct by pressing the 

OK button (page 11).

• If “CABLE DISCONNECTED” appears on the screen:
– Check that the video signal cables are properly connected.
– Check that the input signal setting is correct by pressing the 

OK button (page 11).

• If “OUT OF RANGE” appears on the screen:

Reconnect the old display. Then adjust the computer’s graphics 
board within the following ranges.

For more information about the on-screen messages, see “Trouble 
symptoms and remedies” on page 19.

No need for specific drivers
The display complies with the “DDC” Plug & Play standard and 
automatically detects all the display’s information. No specific driver 
needs to be installed to the computer.
The first time you turn on your computer after connecting the display, the 
setup Wizard may appear on the screen. If this is the case, follow the on-
screen instructions. The Plug & Play display is automatically selected so 
that you can use this display. 

The vertical frequency turns to 60 Hz. 
Since flickers are unobtrusive on the display, you can use it as is. You do 
not need to set the vertical frequency to any particular high value.

This display can be adjusted within the angles shown below.

When you use the height adjustable stand, the height adjust is also 
available as below.

28–80 kHz

28–64 kHz

48–75 Hz

60 Hz

1280 

×  1024 or less

approx. 5°

approx. 20°

approx. 175°

approx. 
175°

approx. 110 mm 
(4 

11

/

32

 inches)