Sony FWD-42B2 User Manual

Page of 289
34
 GB
PC Operation
Controlling the display
You can make various display settings on the screen 
of the PC.
Make sure that the display, PC, and router or hub are 
properly connected with the network cable. Then turn 
on power to the display, the PC, and the router or hub.
There are four display screens, divided by function: 
Information screen, Configure screen, Control screen, 
and Setup screen.
For details on the functions of buttons, see instructions for 
each function of the display. 
1
Start the browser of the PC (Internet 
Explorer 7.0 or later).
2
Enter the IP address that was assigned to 
the display in the previous page as 
“http://xxx.xxx.xxx.xxx”, then press the 
ENTER key on the keyboard.
When a user name and password have 
been set, the “Network Password” screen 
appears. Enter the user name and 
password that were set, and then proceed 
to the next step.
3
Click the function tab at the top of the 
screen and select the desired screen.
Setting items on respective screens
When using the LAN function of the display
Information screen
This screen shows the model name, serial number and 
other display information, as well as the power status 
and the input signal selection.
The screen is for information only. There are no items 
that can be set.
Configure screen
Timer
Lets you make settings for the timer function.
Click “Apply” when done.
Screen Saver
Lets you make settings for the screensaver function.
Click “Apply” when done.
Before setting the “Timer” function, make sure to configure 
the time setting on the Setup screen (page 35).
Control screen
POWER
Switches the display on or off.
INPUT
Lets you select the input signal.
PICTURE MODE
Lets you select the picture mode.
ASPECT
Lets you switch the aspect ratio of the image.
Contrast +/– buttons
Adjust the screen contrast.
Brightness +/– buttons
Adjust the picture brightness.
Chroma +/– buttons
Adjust the color intensity.
Note