3M 11-71315-227-01 User Manual

3M™ MicroTouch™ Display C1500SS Installation Guide 

15 

 

3M Touch Systems Proprietary Information 

After connection, the display will switch on automatically. Before you test your touch 
display, make sure all cables are connected properly. Be sure to tighten all cable screws. 

To test that the display is working properly: 

1.  Turn on your computer. 

2.  Make sure the video image is displayed. If it is not, check the LED to ensure that the 

display is not in power save mode (flashing orange/red). If the LED is not on, turn on 
your display. 

3.  Make sure the video image is centered within the screen area. Use the display 

controls to adjust the image, if necessary. 

You can adjust the horizontal and vertical position, contrast, and brightness to better suit 
your video card and your personal preference. Refer to Chapter 4 for more information 
on using the on-screen menu to adjust the video display. 

Two versions of touch software are included on the CD packaged with your display. We 
strongly recommend you read the README.TXT before you begin any software 
installation.  

X 

X 

X 

 

 

All current controllers (serial and USB) 

 

X 

X 

X 

X 

EX II series  
Serial resistive series  

MicroTouch software includes the touch driver and control panel that enables your touch 
sensor to work with your computer. Once the software is installed, restart your computer 
to load and activate the touch driver. To complete the setup of your display, make sure 
you calibrate the touch sensor. 

After you connect your touch display and install MicroTouch software, you must 
calibrate the touch sensor. Calibration serves two purposes: 
•  Sets the active area of the touch sensor 
•  Aligns the touch sensor’s active area to the underlying video 

To calibrate the touch sensor, open the touch sensor control panel and select Calibrate. 
Follow the directions displayed on the screen. For more information on calibration, refer 
to the online help or the user documentation.