Planar PT1545R User Manual

To setup this display, please refer to the following figure and procedures.
1.  Be sure all equipment is turned off.
2.  Connect the AC power cord to the power connector on the monitor and the other end 
       into an electrical outlet (8.1).
3.  Connect the D-SUB cable from the display's VGA  input connector to the D-SUB 
       connector of your host computer and tighten the screws (8.1).
4.  Connector the audio-in cable from the audio input port of your display to the audio out
       port of your computer (8.1).
5.  Connect the RS-232 or USB cable from the RS-232 or USB port of your display to the
       RS-232 port or USB port (8.1) of your computer.
6.  Configure the touch screen.  Refer to the “Touch Screen Driver Installation” section on
       page 20.
7.  Once the touch screen is configured, the monitor is ready for use.

To ensure the display works well with your computer, please configure the display 
mode of your graphics card to make it less than or equal to 1024 x 768  resolution and 
make sure the timing of the display mode is compatible with the display.
We have listed the compatible “Video Modes” of your display in the appendix 
(on page 19) for your reference. 

7