Planar C3215 User Manual
PCI Configuration Status and Error Messages
The following PCI messages are displayed as a group with bus, device, and function information.
Message
Explanation
Floppy Disk Controller Resource Conflict
The floppy disk controller has requested a
resource that is already in use.
resource that is already in use.
NVRAM Checksum Error,
The ESCD data was reinitialized because of an
NVRAM Cleared
NVRAM checksum error. Rerun the ICU.
NVRAM Cleared By Jumper
The Clear CMOS DIP switch has been moved
to the ON position and CMOS RAM has been
cleared.
to the ON position and CMOS RAM has been
cleared.
NVRAM Data Invalid, NVRAM Cleared
Invalid entry in the ESCD.
Parallel Port Resource Conflict
The parallel port has requested a resource that
is already in use.
is already in use.
PCI Error Log is Full
This message is displayed when more than 15
PCI conflict errors are detected. No additional
PCI errors can be logged.
PCI conflict errors are detected. No additional
PCI errors can be logged.
PCI I/O Port Conflict
Two devices requested the same resource,
resulting in a conflict.
resulting in a conflict.
PCI IRQ Conflict
Two devices requested the same resource,
resulting in a conflict.
resulting in a conflict.
PCI Memory Conflict
Two devices requested the same resource,
resulting in a conflict.
resulting in a conflict.
Primary Boot Device Not Found
The designated primary boot device (hard disk
drive, diskette drive, or CD-ROM drive) could
not be found.
drive, diskette drive, or CD-ROM drive) could
not be found.
Primary IDE Controller Resource Conflict
The primary IDE controller has requested a
resource that is already in use.
resource that is already in use.
Primary Input Device Not Found
The designated primary input device (key-
board, mouse, or other, if input is redirected)
could not be found.
board, mouse, or other, if input is redirected)
could not be found.
Secondary IDE Controller Resource Conflict
The secondary IDE controller has requested a
resource that is already in use.
resource that is already in use.
Serial Port 1 Resource Conflict
Serial port 1 has requested a resource that is
already in use.
already in use.
Serial Port 2 Resource Conflict
Serial port 1 has requested a resource that is
already in use.
already in use.
Static Device Resource Conflict
A non-plug-and-play device has requested a
resource that is already in use.
resource that is already in use.
Device Resource Conflict
A non-plug-and-play device has requested a
resource that is already in use.
resource that is already in use.
44
Planar Clean Screen II PC User’s Manual
CS II Manual LAYOUT#2304 3/25/99 11:16 AM Page 44