Pelco PMM15A User Manual
6
C2902M (10/02)
DESCRIPTION
The PMM9A, PMM12A, PMM15A, and PMM20A are high resolution, black and white, CCTV video monitors. The cabinets are
made of steel for ruggedness and, with the exception of the picture tube, the circuitry is all solid-state for reliability.
made of steel for ruggedness and, with the exception of the picture tube, the circuitry is all solid-state for reliability.
MODELS
PMM9A
Black and white monitor, 9-inch (22.86 cm) picture display, 96-256 VAC, 50/60 Hz, EIA/CCIR, auto-sensing
PMM12A
Same as PMM9A except 12-inch (30.48 cm) picture display
PMM15A
Same as PMM9A except 15-inch (38.10 cm) picture display
PMM20A
Same as PMM9A except 20-inch (50.80 cm) picture display
INSTALLATION
The following parts are supplied:
Monitor
Two power cords (1 USA standard and 1 European standard)
Two power cords (1 USA standard and 1 European standard)
MOUNTING
The monitor has rubber feet and may be placed on any horizontal surface, such as a desk or table. The monitor also can be
mounted to a wall or ceiling with an appropriate mount. If you have a PMM9A, PMM12A, or PMM15A monitor, it can be
installed in a 19-inch equipment rack with a suitable rack-mounting kit. For mounting to a wall or ceiling or in a rack, refer to
the instructions with the mount.
mounted to a wall or ceiling with an appropriate mount. If you have a PMM9A, PMM12A, or PMM15A monitor, it can be
installed in a 19-inch equipment rack with a suitable rack-mounting kit. For mounting to a wall or ceiling or in a rack, refer to
the instructions with the mount.
CONNECTIONS
SINGLE-MONITOR INSTALLATION
Refer to Figure 1 and Table A for the following instructions.
1.
Set the impedance switch on the back of the monitor to LO (75 ohms).
2.
Connect a 75-ohm video cable from the video source, such as a camera, to the BNC connector labeled VIDEO IN (or
INPUT) on the back of the monitor.
INPUT) on the back of the monitor.
3.
Plug in the appropriate power cord.
Figure 1. Singe-Monitor
Installation (PMM15A Shown)