Planar PT150MU User Manual
10
Notice:
To ensure the LCD display can work well with your computer,
please configure the display mode of your graphic card to make it
less than or equal to 1024 x 768 resolution and make sure timing
of the display mode is compatible with the LCD display.
We have listed the “Compatibility Modes” of this LCD display in
appendices for your reference.
please configure the display mode of your graphic card to make it
less than or equal to 1024 x 768 resolution and make sure timing
of the display mode is compatible with the LCD display.
We have listed the “Compatibility Modes” of this LCD display in
appendices for your reference.
Connecting the Display (Figure 11.1)
To setup this display, please refer to the following figure and procedures.
1. Be sure the computer and monitor are turned off.
2. Connect the DC power cord to the power connector; plug one end of
2. Connect the DC power cord to the power connector; plug one end of
the AC power cord into the poweradapter, and then the other end into an
electrical outlet(
electrical outlet(
).
3. Connect the VGA signal cable from display VGA input connector to the
15-pin connector of your host computer and tighten the screws(
).
4. Connect the Audio-In cable from audio input port of your display to the
Audio-out port of your computer(
).
5. Connect the RS-232 cable from RS-232 port of your display to the
RS-232 port of your computer(
).
6. Turn on your computer, display and video source.