Planar SD2420W User Manual
User’s Guide | 7
Connect the cables
The SD2420W unit comes with one 6-foot DVI cable, one 12-foot DVI cable,
and one 14-inch DVI cable.
and one 14-inch DVI cable.
1. Plug one end of the 6-foot DVI
cable into the primary port of
the dual-channel DVI graphics
card. Plug the other end into
the bottom monitor of the
SD2420W unit.
the dual-channel DVI graphics
card. Plug the other end into
the bottom monitor of the
SD2420W unit.
2. Plug one end of the 14-inch DVI
cable into the secondary output
of the dual-channel graphics
card. Plug the other end into
the input port (labeled “IN”) of
the mirror-flip PCI card.
of the dual-channel graphics
card. Plug the other end into
the input port (labeled “IN”) of
the mirror-flip PCI card.
3. Plug one end of the 12-foot DVI cable
into the output port of the mirror-flip
PCI card (labeled “OUT”). Plug the
other end into the top monitor of
the SD2420W unit.
PCI card (labeled “OUT”). Plug the
other end into the top monitor of
the SD2420W unit.
The two monitors must be connected with an off-the-shelf video
cable to comply with FCC regulations. Ferrite-core interface
cables are provided. This device will not be in compliance with
FCC regulations when a non-ferrite-core video cable is used.
cable to comply with FCC regulations. Ferrite-core interface
cables are provided. This device will not be in compliance with
FCC regulations when a non-ferrite-core video cable is used.
Short DVI cable installed