Pelco C1970M-A User Manual

Page of 16
14
Pelco Manual C1970M-A (7/01)
TECHNICAL SPECIFICATIONS
ELECTRICAL
Input Voltage:
100 to 240 VAC, 50/60 Hz
Power Consumption:
70 watts
Signal Format:
NTSC
Scanning System:
2:1 interlace
Picture Elements:
512 (H) x 492 (V)
Horizontal Resolution:
350 TV lines (center)
Linearity:
Less than 12%
Audio Output:
1.1 W +/-0.2 W at 8-ohm resistive load
Pixel Format
Single Screen:
720 (H) x 480 (V)
Quad Screen:
360 (H) x 240 (V)
PIP Screen:
208 (H) x 136 (V)
Refresh Rate:
30 frames per second (NTSC)
Digital Zoom:
2X
OSD Character:
16 x 20 bit map font (upper case alpha characters, numbers, and
symbols)
Video Switching
Time When Multiple
Alarms Occur:
1 second
Maximum Character
Display Format:
45 (H) x 24 (V) (1,080 characters)
GENERAL
Picture Tube:
14-inch diagonal color
Controls:
Sharpness, color, brightness, contrast, tint, and volume
Character Display:
8 alphanumeric characters each for camera, date, time, alarm,
video loss, and freeze for each channel
Display Modes:
One camera, four cameras (quad), picture-in-picture (PIP), and
VCR
Sequential
Switching Mode:
Set dwell time from 1 to 30 seconds; OFF setting skips channel
Video Loss
Detection:
All channels
Time Mode:
12-hour mode with AM/PM indicator
Alarm Inputs:
4, activated by N.O. or N.C. contact
closure (programmable)
Alarm Output:
1, common to all 4 inputs, TTL compatible (programmable for high
or low output)
Alarm Beep:
On or off (programmable)
Automatic
Alarm Reset:
Set reset time from 1 to 60 seconds; OFF setting defeats auto
reset (programmable)
Video/Audio
Input Connectors:
4X6P mini-DIN
Video Input
Connectors:
4 BNC
Video Looping
Connectors:
4 BNC
Monitor Output
Connector:
1 BNC
VCR Input/Output
Connectors:
4 RCA (2 video and 2 audio)
Remote Port
Connector:
DB9 male
Alarm Connector:
10-position, snap-in type (push-in wire
Impedance
Termination:
75 ohms or bridging for 4 video inputs (from cameras) and 1
monitor output
Dimensions:
13.68 (W) x 12.75 (H) x 14.68 (D) inches
(34.75 x 32.38 x 37.29 cm)
Weight:
28.6 lb (13 kg)