NEC LCD8205-P User Manual
English-6
4. Attach Mounting Accessories
The display is designed for use with the VESA mounting
system.
system.
When using mounting accessories other than NEC
compliant and approved, they must comply with the VESA-
compatible mounting method. NEC strongly recommends
using screws M8 size and 10 - 18 mm in length. If using
screws longer than 18 mm, check the depth of the hole.
(Recommended Fasten Force: 1125 - 1375N•cm)
compliant and approved, they must comply with the VESA-
compatible mounting method. NEC strongly recommends
using screws M8 size and 10 - 18 mm in length. If using
screws longer than 18 mm, check the depth of the hole.
(Recommended Fasten Force: 1125 - 1375N•cm)
NEC recommends using a mounting interface that complies
with UL1678 standard in North America.
with UL1678 standard in North America.
Attaching Mounting Accessories
The display is designed for use with the VESA mounting
system.
system.
In order to aid in mounting, a lifting device must be
used in conjunction with the attachable eyebolts.
used in conjunction with the attachable eyebolts.
1. Attach eyebolts for mounting
This model is equipped with attachable eyebolts to aid in
mounting.
mounting.
•
Place the washer over the threads of the eyebolt.
•
Screw the eyebolts into eyebolt holes as shown in the
picture.
picture.
•
Be sure eyebolts are secure.
•
In order to move the monitor into position, use a lifting
device attached to the eyebolts.
device attached to the eyebolts.
DO NOT mount the monitor using only the eyebolts.
Use an approved mounting accessory.
3. Ventilation Requirements
When mounting in an enclosed space or recessed area,
leave adequate room between the monitor and the
enclosure to allow heat to disperse, as shown below.
leave adequate room between the monitor and the
enclosure to allow heat to disperse, as shown below.
Eyebolt Hole
Eyebolt
Washer
2. Attach Mounting Accessories
Be careful to avoid tipping monitor when attaching
accessories. After accessories are attached, stand can
be removed.
accessories. After accessories are attached, stand can
be removed.
Mounting accessories can be attached with the monitor in
the face down position. To avoid damaging the screen face,
place the protective sheet on the table underneath the LCD.
The protective sheet was wrapped around the LCD in the
original packaging. Make sure there is nothing on the table
that can damage the monitor.
the face down position. To avoid damaging the screen face,
place the protective sheet on the table underneath the LCD.
The protective sheet was wrapped around the LCD in the
original packaging. Make sure there is nothing on the table
that can damage the monitor.
When using mounting accessories other than NEC
compliant and approved, they must comply with the VESA-
compatible mounting method. NEC strongly recommends
using screws M8 size and 10 - 18 mm in length. If using
screws longer than 18 mm, check the depth of the hole.
(Recommended Fasten Force: 1125-1375N•cm)
compliant and approved, they must comply with the VESA-
compatible mounting method. NEC strongly recommends
using screws M8 size and 10 - 18 mm in length. If using
screws longer than 18 mm, check the depth of the hole.
(Recommended Fasten Force: 1125-1375N•cm)
NEC recommends using a mounting interface that complies
with UL1678 standard in North America.
with UL1678 standard in North America.
VESA Mounting Interface