NEC A700 Plus User Manual
Quick Start
To attach the MultiSync A Series monitor to your system,
follow these instructions:
follow these instructions:
1. Turn off the power to your computer and MultiSync monitor.
2. If necessary, install the display card. For more information, refer to the
display card manual.
3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable
to the connector of the display card in your system (Figure A.1).
Tighten all screws.
Tighten all screws.
For the Mac: Connect the MultiSync A500+ or MultiSync A700+
Macintosh Cable Adapter (not included) to the monitor connector on
the Macintosh (Figure B.1). Attach the 15-pin mini D-SUB end of the
captive signal cable to the Macintosh cable adapter on the computer
(Figure B.1). Tighten all screws.
Macintosh Cable Adapter (not included) to the monitor connector on
the Macintosh (Figure B.1). Attach the 15-pin mini D-SUB end of the
captive signal cable to the Macintosh cable adapter on the computer
(Figure B.1). Tighten all screws.
4. Connect one end of the power cord to the MultiSync A Series monitor
and the other end to the power outlet (Figure C.1).
5. Turn on the monitor (Figure D.1) and the computer.
6. This completes the installation.
NOTE:
If you have any problems, please refer to the Troubleshooting
section of this User's Manual.
section of this User's Manual.
Figure A.1
Captive Signal Cable
15-pin mini D-SUB
E - 2
0
5
25
75
95
100
ENGLISH.CHP
Sun Oct 11 19:37:12 1998
Farbprofil: Deaktiviert
Komposit Standardbildschirm