NEC 42/50PD1 User Manual

20

Connecting your PC or Macintosh computer to your
PlasmaSync 42/50PD1 will enable you to display your
computer's screen image. All of these following display
standards are supported:

To connect to a PC, Macintosh or computer equipped with
an XGA/SuperVGA/VGA adapter or compatible graphics
adapter, simply:
1. Turn off the power to your monitor and computer.
2. If your PC does not support XGA/SuperVGA/VGA

you will need to install an XGA/SuperVGA/VGA
graphics board. Consult your computer's owner's
manual for your XGA/SuperVGA/VGA configuration.
If you need to install a new board, see the manual that
comes with your new graphics board for installation in-
structions.

3. Use the signal cable that’s supplied to connect your PC

or Macintosh computer to the RGB1 input terminal.

4. Turn on the monitor and the computer.

Note: Refer to your computer's owner's manual for
more information about your computer's video output
requirements and any special identification or
configuring your monitor's image and monitor may
require.

Use a composite video cable with BNC connector and
RCA video cables (not provided) to connect your VCR,
DVD or laser disc player to your PlasmaSync 42/50PD1.
To make these connections, simply:
1. Turn off the power to your monitor and VCR, DVD or

laser disc player.

2. Connect one end of your video cable to the video out-

put connector on the back of your VCR, DVD or laser
disc player, connect the other and to the VIDEO input
terminal (BNC type) of the monitor.
NOTE: You will need a BNC to RCA adapter (not in-
cluded) to connect a video cable with an RCA pin jack to
the BNC input terminal of the PlasmaSync 42/50PD1.

3. Turn on the monitor and the VCR, DVD or laser disc

player.

Note: Refer to your VCR or laser disc player owner's
manual for more information about your equipment's
video output requirements.

Note: S-VIDEO  IN terminals  will take preference
over VIDEO IN terminals when a component is
connected to each terminal and S-VIDEO selected.

You can connect your PlasmaSync 

42/50PD1

 to a document

camera. To do so, simply:

1. Turn off the power to your monitor and document

camera.

2. Use a standard video cable to connect your document

camera to the VIDEO input terminal(BNC-type) of the
monitor.

3. Turn on the monitor and the document camera.

Note: Refer to your document camera's owner's
manual for more information about your camera's
video output requirements .

Connections can be made with equipment that is equipped

with a digital interface compliant with the DVI (Digital

Visual Interface) standard.

* Use a DVI 29-pin signal cable (available separately)

and the ferrite cores (supplied) when making connec-

tions to the RGB3 IN (DVI) connector of the main unit.