Roland DM-5 User Manual
16
Reference
Troubleshooting
If there is no sound or if the unit does not operate as you expect, please check the following points
first. If this does not resolve the problem, contact the nearest Roland/EDIROL service center or
authorized Roland/EDIROL distributor.
first. If this does not resolve the problem, contact the nearest Roland/EDIROL service center or
authorized Roland/EDIROL distributor.
There’s No Sound
• Make sure the Input Level control has not been turned fully counterclockwise.
• Make sure the Input Select switch has been set to the connector where the input signal is
• Make sure the Input Select switch has been set to the connector where the input signal is
connected (Digital Input or Analog Input).
• Make sure the Digital Input select switch has been set to the connector where the input signal is
connected (Optical or Coaxial).
• Input a digital signal to the Digital Input connector. No sound is produced when an analog signal
is input.
The volume level of the instrument connected to ANALOG INPUT is
too low
too low
• Could you be using a connection cable that contains a resistor? Use a connection cable that does
not contain a resistor.
During Digital Signal Input, the Stereo Image Is Reversed or
Sounds Unnatural, or Output Doesn’t Sound Like Stereo
Sounds Unnatural, or Output Doesn’t Sound Like Stereo
• Check the setting of the Assign switch (Right, L+R, or Left). The DM-5 uses an identical
construction for the left and right monitors, and makes no distinction between left and right.
During digital signal input, set the Assign switch L or R as appropriate for your setup.
During digital signal input, set the Assign switch L or R as appropriate for your setup.