MAXTECH XT5861 User Manual

4

• Plug the 15-pin male connector on the video cable into the output

connector on the rear of your computer system. The video output
connector on your computer may be either in a location similar to
Figure 2-2

 

or on an expansion board. Secure the cable to the

computer using the thumbscrews on the 15-pin connector.

• Attach the power cord to the monitor and plug it into an AC outlet.
• The monitor is now ready for use.

Power Indicators: LEDs A and B indicate the state of the Monitor.
•

LED A On (green)  Normal operations.

•

LED A flashing  DPMS (Display Power Management Signaling)
“STAND-BY” mode.

•

LED B On (orange)  DPMS “OFF” mode.

Power Switch: Push to turn the monitor ON, push again to turn the
monitor OFF.

Trapezoid: Adjusts the angle of the sides of the display to make the
display rectangular.

Pincushion: Adjusts the curvature of the sides of the display to make
the sides straight.

Vertical-Position: Adjusts the vertical position

A

B

1

2

3

4

5

6

7

10

9

8