Seagate ST136475LW/LC User Manual
Barracuda 36 Installation Guide, Rev. B
19
Initial setup information
The general information beginning on this page applies to all of
the Barracuda 36 drive models. After reading the general infor-
mation topics, refer to the appropriate drive-specific section
listed below for additional information about configuring and
installing your particular model.
the Barracuda 36 drive models. After reading the general infor-
mation topics, refer to the appropriate drive-specific section
listed below for additional information about configuring and
installing your particular model.
Drive models
Page
ST136475LW
ST136475LC
General information
The following general information topics are discussed:
• SCSI ID jumpers
• Drive termination
• Terminator power
• Interface drivers and data path width notes
• Other applicable jumper options
• Providing adequate cooling
• Mounting the drive and connecting cables
• Drive termination
• Terminator power
• Interface drivers and data path width notes
• Other applicable jumper options
• Providing adequate cooling
• Mounting the drive and connecting cables
1
• Formatting the drive
1
This mounting procedure does not apply to “LC” model drives.
To mount an “LC” drive, plug the drive into the system’s single
connector attachment (SCA) position on the system’s back
panel.
connector attachment (SCA) position on the system’s back
panel.