Netgear Business Edition User Manual
ReadyNAS Pro Business Edition User Guide
Setting Up and Managing Your ReadyNAS Pro
2-7
v1.3, November 2008
DHCP
The DHCP tab allows you to specify this device as a DHCP (Dynamic Host Configuration
Protocol) server. DHCP service simplifies management of a network by dynamically assigning IP
addresses to new clients on the network.
Protocol) server. DHCP service simplifies management of a network by dynamically assigning IP
addresses to new clients on the network.
Select the Enable DHCP service check box if you want the ReadyNAS Pro Business Edition
device to act as a DHCP server. This is convenient in networks where DHCP service is not already
available.
device to act as a DHCP server. This is convenient in networks where DHCP service is not already
available.
Route: A Manual Routing Table
The Route tab allows you to specify a manual routing table for each Ethernet interface. You can
use this option to optimize performance. For example, you could configure a manual routing table
to assure that these Ethernet interfaces were directly routed over a fiber backbone to assure that the
unit would not experience the traffic congestion that can build up on a gigabit segment.
use this option to optimize performance. For example, you could configure a manual routing table
to assure that these Ethernet interfaces were directly routed over a fiber backbone to assure that the
unit would not experience the traffic congestion that can build up on a gigabit segment.
Figure 2-10
Note: These options are available only if this device is not already using a DHCP address.
Enabling DHCP service on a network already utilizing another DHCP server will
result in conflicts. If you wish to use this device as a DHCP server, make sure to
specify static addresses in the Ethernet and DNS tabs.
result in conflicts. If you wish to use this device as a DHCP server, make sure to
specify static addresses in the Ethernet and DNS tabs.
Figure 2-11