Hypercom ICE 6500 User Manual

Reloading Printer Paper

To properly install the printer paper, read the following steps carefully.

You can also access this function by Merchant Functions, 1, 5, and pressing or touching Enter.

To load printer paper:

1.

Place the paper roll into the printer paper holder, making sure the printer paper feeds from under 
the roll, not over the top, and has a straight-line path into the printer paper-feed mechanism.

Figure 1-6. ICE 5700 printer paper installation

2.

Place the end of the paper in the paper guide. The printer then automatically feeds the paper. If 
the printer does not feed automatically, proceed with step 3. Otherwise, proceed to step 9.

3.

At the main terminal display, touch Press Here for Menu.

4.

Touch Setup. The Setup menu appears.

5.

Touch Printer. The Printer prompt appears.

6.

Touch Paper Feed. The Paper Feed menu appears.

7.

Touch Paper Feed until the paper feeds through the paper cutter mechanism.

If the printer fails to 

advance the paper, check the printer ON/OFF settings as follows:

a.  At the main terminal display, touch Press Here for Menu.

b.  Touch Setup. The Setup menu appears.

c.  Touch Printer. The Printer prompt appears.

d.  Touch On/Off. The Printer Toggle menu appears displaying Printer is disabled. Enable?.

e.  Touch Yes. The terminal changes the printer settings to Enabled and returns to the Idle 

prompt. Repeat steps 3 through 7.

8.

Touch Quit. The system returns to the Idle prompt.

9.

Close the printer paper cover.