Panasonic AJ-HRW10G User Manual

14

When inserting a P2 card into the P2 card slot of the 
P2 drive provided in the unit, be absolutely sure to 
position the P2 card parallel to the slot and insert it 
straight into the drive.

Insert the card with the 
logo facing up.

Blinks in 
green

Being 
accessed

Reading is being performed.

Quickly 
blinks in 
green

Being 
recognized

The P2 card is being 
recognized.

Stays off

Card not 
supported

The card is not supported by 
the unit. Use another card.

Incorrect 
format

The P2 card is not properly 
formatted. Reformat the card.

Card not 
inserted

No P2 card is inserted.
Card recognition standby.

•  Forcing cards in the slot at an angle may damage P2 

card, P2 Drive or this unit.

•  To prevent cards from falling out, protect the unit 

from dust, and reduce the risk of exposure to static 
electricity, remove P2 cards before moving the unit.

•  Format P2 cards only on a P2 card device.

When a P2 card is inserted, an icon is displayed on the 
control panel.
Also at this time, the P2 CARD ACCESS LED for the 
corresponding slot indicates the status of the P2 card.

EJECT button

•  During access or detection of P2 cards after insertion 

(when the P2 CARD ACCESS LED blinks in green), 
do not remove the cards. Removing cards during 
access may damage them.

•  If a P2 card being formatted is removed, it may not 

be formatted properly.

•  Do not move the unit while the EJECT button is set 

to its out position.  Doing so may cause damage. Be 
sure to press the EJECT button and set it to its in 
position first.

To prevent the content of a P2 card being accidentally 
erased, position the write-protect switch on the P2 card 
at [Protect].

Write-protect 
switch

Write-protect switchover can be performed while the 
card is being accessed (during recording or playback), 
but does not take effect until access to the card 
ceases.