Packard Bell 5800 User Manual
PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off
top and right edge. Left side of page extends to 9.25 inches.
top and right edge. Left side of page extends to 9.25 inches.
7
After setting the cabinet identifications you must
power cycle the subsystem. Observe normal power
cycling precautions by waiting a minimum of five (5)
seconds before adding power again.
power cycle the subsystem. Observe normal power
cycling precautions by waiting a minimum of five (5)
seconds before adding power again.
This will reset the SCSI IDs to a default setting that
prevents a SCSI ID conflict under normal conditions.
8
Power up your computer system and run the
configuration program.
configuration program.
This completes the hardware installation.
S i n g l e- Bu s Cab i n et
The Single-Bus module links all of the drives in the
DEU cabinet to a single SCSI bus. This configuration
provides the user with access to the drives
independently or as a single large array.
DEU cabinet to a single SCSI bus. This configuration
provides the user with access to the drives
independently or as a single large array.
The SCSI IDs of the drives are set by SAF-TE card
defaults to IDs 0 through 9, and are assigned
sequentially beginning with the lowest or far right
drive.
defaults to IDs 0 through 9, and are assigned
sequentially beginning with the lowest or far right
drive.
Note: SCSI ID 3 is reserved for the SAF-TE card
processor and ID 7 reserved for the RAID controller.
processor and ID 7 reserved for the RAID controller.
Caution: Ensure that the power switch is in the OFF
(O) position for both the host system and the DEU
subsystem before connecting any cables.
(O) position for both the host system and the DEU
subsystem before connecting any cables.
1
Connect one end of a one meter data cable to the
Channel #1 connector on the Host Controller.
Channel #1 connector on the Host Controller.
2
Connect the other end of the data cable to the
Channel 1 SCSI connector on the upper or right side
I/O Interface card.
Channel 1 SCSI connector on the upper or right side
I/O Interface card.
Note: The Channel 1 connector located on the upper or
right side I/O Interface card is the active connector
when the Single-Bus module is installed.
right side I/O Interface card is the active connector
when the Single-Bus module is installed.