ONKYO BR925 User Manual

6

Notes:
• If the remote controller doesn’t work reliably, try replac-

ing the batteries.

• Don’t mix new and old batteries or different types of bat-

teries.

• If you intend not to use the remote controller for a long 

time, remove the batteries to prevent damage from leak-
age or corrosion.

• Expired batteries should be removed as soon as possible 

to prevent damage from leakage or corrosion.

• When replacing the batteries, use R6/AA batteries. 

Onkyo recommend that you use manganese dry batteries.

• If rechargeable batteries are used, the remote controller 

may be inoperable.

When you operate the remote controller, point it at the 
CD/HDD receiver’s remote control sensor, as shown 
below.

Notes:
• The remote controller may not work reliably if the CD/

HDD receiver is subjected to bright light, such as direct 
sunlight or inverter-type fluorescent lights. Keep this in 
mind when installing.

• If another remote controller of the same type is used in 

the same room, or the CD/HDD receiver is installed close 
to equipment that uses infrared rays, the remote control-
ler may not work reliably.

• Don’t put anything, such as a book, on the remote con-

troller because the buttons may be pressed inadvertently, 
thereby draining the batteries.

• The remote controller may not work reliably if the CD/

HDD receiver is installed in a rack behind colored glass 
doors. Keep this in mind when installing.

• The remote controller will not work if there’s an obstacle 

between it and the CD/HDD receiver’s remote control 
sensor.

Insert two batteries (R6/AA) into the bat-
tery compartment.
Carefully follow the polarity diagram (positive 
(+) and negative (–) symbols) inside the battery 
compartment.

Ap

pro

x. 

5 m

Remote control sensor

CD/HDD receiver