Seagate ST19171WC User Manual
Barracuda 9 Installation Guide, Rev. B
31
tem einbauen. Die daraus u.U. resultierende verstärkte
elektromagnetische Strahlung fällt in den Zuständigkeits-
bereich des Systemdesigners.
elektromagnetische Strahlung fällt in den Zuständigkeits-
bereich des Systemdesigners.
5.
Replace the host system’s cover.
5.
Setzen Sie das Gehäuseoberteil des Host-Systems wieder
auf.
auf.
Formatting the drive
Warning. Formatting a drive erases all user data. Be sure that
you understand this principle before formatting any
hard disc drive. It is not necessary to format a drive
that previously has been used to store data, unless
your intention is to erase all user data.
hard disc drive. It is not necessary to format a drive
that previously has been used to store data, unless
your intention is to erase all user data.
1.
Turn on DC power.
2.
Boot the system from a system floppy disc or from a previ-
ously installed hard disc drive if there is one.
ously installed hard disc drive if there is one.
3.
Format the disc drive. Barracuda 9 disc drives are designed
to operate with a variety of operating systems. Please refer
to your system or SCSI controller manual for information
about formatting and setting up the drive. Some quick desk-
top system notes are provided below.
to operate with a variety of operating systems. Please refer
to your system or SCSI controller manual for information
about formatting and setting up the drive. Some quick desk-
top system notes are provided below.
Quick reference desktop system notes
Note. Refer to your system or utility manual for detailed instruc-
tions)
• DOS. Set the drive type in CMOS to “
Zero,” “None,” or “No
hard drive installed.” Use FDISK.exe and FORMAT.exe.
• Macintosh. Use a third-party drive utility (Apple’s HD Setup
utility only works with Apple firmware drives).