Maxtor 10K III User Manual
SCSI Description
Maxtor Atlas 10K III
5-63
Table 5-79
Power Condition Page-Field Descriptions (Page 1Ah)
&*2,
"?2
<2
"()**+
PS
0
Parameters Savable. This bit is only used with the MODE SENSE com-
mand. A returned value of 1 indicates that the target is capable of saving
the page in a non-volatile, vendor-specific location. The bit is reserved
with the MODE SELECT command.
mand. A returned value of 1 indicates that the target is capable of saving
the page in a non-volatile, vendor-specific location. The bit is reserved
with the MODE SELECT command.
IdlEnb
0
Enable Idle Timer. This is a lower power consumption state of the drive.
A media access command waits for an approximately one second transi-
tion time delay from the IDLE to the ACTIVE state.
A media access command waits for an approximately one second transi-
tion time delay from the IDLE to the ACTIVE state.
SbyEnb
0
Enable Standby Timer. Any media access command waits for an approxi-
mately 10 second transition time delay from the STANDBY to the ACTIVE
state.
mately 10 second transition time delay from the STANDBY to the ACTIVE
state.
Idle Timer
0
The Idle Timer specifies the time, in 100-millisecond increments, before
entering the IDLE state after the last media access command. The IdlEnb
field must be set to 1. The internal minimum value for this field is 60 sec-
onds.
entering the IDLE state after the last media access command. The IdlEnb
field must be set to 1. The internal minimum value for this field is 60 sec-
onds.
Standby
Timer
0
The Standby Timer specifies the time, in 100-millisecond increments, be-
fore entering the Standby state after the last media access command. The
SbyEnb field must be set to 1. The internal minimum value for this field is
15 minutes.
fore entering the Standby state after the last media access command. The
SbyEnb field must be set to 1. The internal minimum value for this field is
15 minutes.