Maxtor 10K III User Manual
Installation
Maxtor Atlas 10K III 3-13
Configure the desired spin up option (Table 3-3) by setting the state of the
DELAY_SPIN (Pin 38) and STAGGER_SPIN (Pin 78) inputs on the 80-pin SCA-
2 connector (Figure 3-5). The states of these signals are set by using either hard-
wired connections at the backplane or backplane logic.
DELAY_SPIN (Pin 38) and STAGGER_SPIN (Pin 78) inputs on the 80-pin SCA-
2 connector (Figure 3-5). The states of these signals are set by using either hard-
wired connections at the backplane or backplane logic.
12$$
Spin Up on Power On Options
$3%3$3%
)*@*5 "?++)+<(*+(
The drive provides the output BUSY_OUT signal to power a user-supplied activity
LED.
LED.
The output indicates the drive is performing a SCSI operation. To use this output,
connect a user-supplied LED cathode to the BUSY_OUT connection, pin 77 on
the SCA Connector (Figure 3-5). The LED anode must be attached to the proper
+5 VDC supply through an appropriate current-limiting resistor.
connect a user-supplied LED cathode to the BUSY_OUT connection, pin 77 on
the SCA Connector (Figure 3-5). The LED anode must be attached to the proper
+5 VDC supply through an appropriate current-limiting resistor.
Option
STAGGER_SPIN (Pin 78)
DELAY_SPIN (Pin 38)
– Spin Up When Power is Applied
Open
Open
– Spin Up After Delay
Ground
Open
– Spin Up on START Command
Open
Ground
Reserved
Ground
Ground