Ricoh MP9060A User Manual

 

Obey the following cautions when handling the drive or discs.

●   

Install the drive in accordance with the specifications. Be careful to avoid locations likely to cause

vibration or shock.

●   

Avoid locations where there is high humidity, excessive dust, or poor ventilation.

●   

Avoid locations in direct sunlight, with severe changes in humidity, or places where there are extremely

high or low temperature variations.

●   

Don't use the drive near radio or television receivers. It may interfere with their reception.

●   

Do not disassemble the drive. Dismantling the drive to attempt repairs or for other reasons is dangerous

because the laser may radiate outside the unit.

●   

Don't suddenly move the drive from a cold place to a warm place, or suddenly raise the room

temperature. Condensation may occur, causing abnormal operation.

●   

Make sure to remove the disc before moving the drive. The disc may be damaged, causing data loss.

●   

Be careful to prevent foreign objects such as liquids or metal from entering the drive. Should by chance a

foreign object enter the drive, please consult the dealer where the drive was purchased.

●   

Don't use benzene or thinner to clean dirt from the drive. Don't allow chemicals such as insecticides to

contact the drive. Use a soft cloth to wipe the drive, or moisten a cloth with neutral detergent diluted with
water and use it to clean particularly dirty areas.

●   

Don't cutoff the electric power while the drive is operating.

●   

When connecting two E-IDE devices to the Primary or Secondary connectors, make sure that the two

devices are not both configured as Master, or both as Slave. If they are both set the same, Windows may
fail to run or recognize the drives.

●   

The total length of the E-IDE cable should be less than 18 inches (about 45 cm).

●   

Make sure the power to the host computer is turned OFF before connecting.

●   

Never insert a damaged disc into the drive.

●   

In wintertime, don't use a disc soon after bringing in from outdoors. Use it only after it has reached room

temperature.

●   

Remove the disc by pressing the eject button.

●   

Use compressed air to clear dust from the disc. (Spray the compressed air for about 5 seconds).

●   

Check to see if there is dirt on the surface of the disc. Be careful not to touch the disc with the fingers