Sony SAITE1300-S User Manual

Installing the S-AIT Tape Drive Unit / Installing Device Drivers

18

The S-AIT Tape Drive Unit weights about 7 kg (15.4 lb.) 
and has the following dimensions. Make sure that the 
surface where you will install the S-AIT Tape Drive Unit 
is appropriate before installing the unit.

Install the S-AIT Tape Drive Unit on a horizontal surface 
near an AC power outlet. Make sure that you leave gap 
of about 150 mm (5.9 in.) behind the rear of the unit to 
allow air to circulate.

• Always position the unit horizontally.
• Away from moving air, such as fans, open windows, or 

air conditioners.

• Away from devices such as facsimiles to avoid toner 

and paper dust.

The S-AIT Tape Drive Unit should not be stacked. Do 
not place anything on top of the unit.

Verify the power cable plug to make sure that it 
matches the AC IN connector receptacle.

Make sure that the electrical outlet you use to 
connect the unit is properly grounded.

Connect one end of the power cable to the AC IN 
connector and the other end to the power outlet.

If the S-AIT drive does not come with a power 
cable, make sure that you connect a power cable 
appropriate for your country to this connector.

A device driver is host firmware that allows the S-AIT 
Tape Drive Unit to interact with a variety of hosts. 

If your software requires it, install the appropriate device 
driver for your system from the supplied CD-ROM. 
Refer to the instructions on the CD-ROM to install 
device drivers.

The latest device drivers and documentation for the S-
AIT Tape Drive Units are available online. Contact your 
dealer for details.

86 mm (3.4 in.)

370 mm (14.6 in.)

210 mm
(8.3 in.)

50 mm (2.0 in.)

210 mm (8.3 in.)

150 mm
(5.9 in.)

370 mm (14.6 in.)

50 mm (2.0 in.)

Rear

Front

AC Power