Sony SDX-800V/R User Manual
3.Installation
SONY AIT-3Ex drive SDX-800V series Ver.1.1
3-2
1 DR (Desaster Recovery) Mode
2 Emulation Mode
3 AIT Library Interface Mode
4 Reserved
5 Terminator Power (ON)
6 Periodic Cleaning Req (ON)
7 DC Control-1
8 DC Control-2
2 Emulation Mode
3 AIT Library Interface Mode
4 Reserved
5 Terminator Power (ON)
6 Periodic Cleaning Req (ON)
7 DC Control-1
8 DC Control-2
1 2 3 4 5 6 7 8
ON
OFF
Figure 3-2: DIP Switch Positions
Table 3-1: Drive Mode
DIP
SW
1 2 3 4
MODE
OFF OFF
ON
OFF
Normal
ON OFF
OFF
OFF
DR
Mode
OFF
ON
OFF
OFF
SDX-700C Emulation Mode
OFF OFF
ON
OFF
Library
Mode
Table 3-2: Periodic Cleaning Request (Refer to 4.6.1.2)
DIP SW 6
Definition
OFF
Disable Periodic Cleaning Request
ON
Enable Periodic Cleaning Request
3.1.1. SCSI ID Number Jumper
The SCSI ID number of the SDX-800V is selected by the SCSI ID number jumpers. The figure below shows the
jumper configuration for each of the possible SCSI IDs.
jumper configuration for each of the possible SCSI IDs.
SCSI ID3 ID2 ID1 ID0
0 : : : :
1 : : : |
2 : : | :
3 : : | |
4 : | : :
5 : | : |
6 : | | :
7 : | | |
8 | : : :
9 | : : |
10 | : | :
11 | : | |
12 | | : :
13 | | : |
14 | | | :
15 | | | |
0 : : : :
1 : : : |
2 : : | :
3 : : | |
4 : | : :
5 : | : |
6 : | | :
7 : | | |
8 | : : :
9 | : : |
10 | : | :
11 | : | |
12 | | : :
13 | | : |
14 | | | :
15 | | | |
: = OPEN
Jumper not installed
| = CLOSED
Jumper installed
3.1.2. Termination Power Switch
Position 5 of DIP switch is used to set whether SDX-800V provides the termination power to pin 17,18,51,52 on SCSI
bus, or not.
bus, or not.
Parity Disable
No Connection
ID3
ID2
ID1
ID0
ID3
ID2
ID1
ID0
Figure 3-3: Jumper positions