Sony SDX-800V/R User Manual

6-18 

 

SONY AIT-3Ex drive SDX-800V series Ver.1.1 

The following parameter codes are supported for each Error Counters Page: 

Code 

Description 

Cumulative 

0003h 

Total Errors Corrected (Soft Errors) 

4 

0 

FFFFFFFFh

0004h 

Total Times Correction  

4 

0 

FFFFFFFFh

0005h 

Total Groups Processed (Algorithm 
Processed) 

4 0 

FFFFFFFFh

0006h 

Total Errors Uncorrected (Hard Errors) 

4 

0 

FFFFFFFFh

         

This page is used to report information on soft and hard errors encountered by the device during normal operation. 
Each parameter  corresponds to an encountered error and is a report of what type of error occurred and when it 

occurred. The format of the page is given below: 

Reserved 

Page Code (07h) 

Reserved 

(MSB) 

Page Length (n*14) 

 

  

(LSB) 

(MSB) Parameter 

Code 

 

  

(LSB) 

DU (0) 

DS (1) 

TSD (0)

ETC (0)

TMC (00) 

LBIN (0)

 LP 

(0) 

Parameter Length (0Ah) 

 Parameter 

Value  

 

 

 

The Parameter Codes supported are 1 through 30 where 30 is the maximum number of entries in the log page. 

If there are no entries, the command will return the Page Header with the Page Length field set to ZERO. 

Each  error event record contains diagnostic information for a single error encountered by the device. The parameter 

codes associated with the error-event records indicate the order in which the errors occurred. A higher parameter 

code indicates that the error event occurred later in time. 

Each parameter entry is 10 bytes long and has the following format: 

Byte Offset 

Meaning 

0 – 4 

5 

6 – 9 

Result Message (see Diagnostic Clause) 
Unused 
Time-stamp (number of 1 minute  increments since power-on) 

When the log page becomes full, no more entries will be added until the log is cleared (using one of the methods 

described previously) or a reset occurs. The current cumulative values will be returned regardless of the page 

control field in the LOG SENSE CDB.