SSD COMPANY LIMITED 637f User Manual
Safety Precautions
________________________________________________________________________________________________________________________________________________________________________________________________________________________
07-02-10-01-E-V0505.doc
Product Manaul Type: 637f
9
Please
observe!
observe!
Pay Special Attention to the Following:
Permissible Protection Class: Protective Grounding - operation is only permitted
when the protective conductor is connected according to regulations.
The operation of servo drives is not allowed, under the sole use of a residual
current operated protective device as protection against indirect touching. The
servo drive may only be used in the rack or in its compact enclosure.
Furthermore the regulator is designed solely for control cabinet operation.
Work on or with the servo drive may only be carried out with insulated tools.
Installation work may only be done in a de-energized state. When working on
the drive, one should not only block the active – input, but also separate the
drive completely from the main power connection.
CAUTION - Risk of Electrical Shock:
Wait 3 minutes after switching the component off, to allow the capacitors to
discharge.
Screws sealed with varnish fulfill an important protection function and may not
be moved or removed.
It is prohibited to penetrate the inside of the unit with objects of any kind.
Protect the unit from falling parts, pieces of wire, metal parts, etc., during
installation or other work in the control cabinet. Metal parts can lead to
a short-circuit in the servo drive.
Before putting the unit into operation, remove additional covers so that the unit
does not overheat. With measurements at the servo drive it is absolutely
necessary to observe the potential separation
Permissible Protection Class: Protective Grounding - operation is only permitted
when the protective conductor is connected according to regulations.
The operation of servo drives is not allowed, under the sole use of a residual
current operated protective device as protection against indirect touching. The
servo drive may only be used in the rack or in its compact enclosure.
Furthermore the regulator is designed solely for control cabinet operation.
Work on or with the servo drive may only be carried out with insulated tools.
Installation work may only be done in a de-energized state. When working on
the drive, one should not only block the active – input, but also separate the
drive completely from the main power connection.
CAUTION - Risk of Electrical Shock:
Wait 3 minutes after switching the component off, to allow the capacitors to
discharge.
Screws sealed with varnish fulfill an important protection function and may not
be moved or removed.
It is prohibited to penetrate the inside of the unit with objects of any kind.
Protect the unit from falling parts, pieces of wire, metal parts, etc., during
installation or other work in the control cabinet. Metal parts can lead to
a short-circuit in the servo drive.
Before putting the unit into operation, remove additional covers so that the unit
does not overheat. With measurements at the servo drive it is absolutely
necessary to observe the potential separation
Stop !
SSD Drives GmbH is not liable for damages which may occur when the
instructions and/or the applicable regulations are not explicitly observed!