DELL DL2100 User Manual

Installing System Components

87

 

NOTE: 

When installing, hot-swapping, or hot-adding a new power supply, allow 

several seconds for the system to recognize the power supply and determine its 
status. The power-supply status indicator turns green to signify that the power 
supply is functioning properly (see Figure 1-5).

Removing the Power Supply Blank

If you are installing a second power supply, remove the power supply blank in 
the bay by pulling outward on the blank.

 

CAUTION: 

To ensure proper system cooling, the power supply blank must be 

installed in the second power supply bay in a non-redundant configuration. 
Remove the power supply blank only if you are installing a second power supply.

Installing the Power Supply Blank

 

NOTE: 

Install the power supply blank only in the second power supply bay. 

To install the power supply blank, align the blank with the power supply bay 
and insert it into the chassis until it clicks into place.

Internal SD Module

Installing the Internal SD Module

 

CAUTION: 

Many repairs may only be done by a certified service technician. You 

should only perform troubleshooting and simple repairs as authorized in your 
product documentation, or as directed by the online or telephone service and 
support team. Damage due to servicing that is not authorized by Dell is not covered 
by your warranty. Read and follow the safety instructions that came with the 
product.

1 Turn off the system, including any attached peripherals, and disconnect 

the system from the electrical outlet.

2 Open the system. See "Opening the System."
3 Position the module so the tabs on the underside of the tray fit into the 

hooks on the chassis, then lower the opposite edge of the card into place. 
See Figure 3-9.