Hitachi HUS154530VLF400 User Manual
Hitachi Ultrastar 15K450 (FC-AL) Hard Disk Drive Specification
119
Format
Description
000b Block
format
100b
Bytes From Index format
101b Physical
Sector
format
If the FmtData bit is set to zero, this field must also be zero. Otherwise the command will complete with a CHECK
CONDITION with a sense key of Illegal Request and an additional sense code of Invalid Field in CDB.
CONDITION with a sense key of Illegal Request and an additional sense code of Invalid Field in CDB.
•Notes:It is recommended that the MODE SELECT command be issued prior to the FORMAT UNIT command to specify
parameters that affect the formatting process.
The Block Length parameter of the Mode Select Parameter List’s Block Descriptor is used during formatting and is
saved following a successful format operation. If a MODE SELECT command has not been issued since the last reset
or start-up (bring-up) sequence, then the Block Length from the previous format operation is used.
saved following a successful format operation. If a MODE SELECT command has not been issued since the last reset
or start-up (bring-up) sequence, then the Block Length from the previous format operation is used.
Subsequent to receiving a FORMAT UNIT command, the Target responds to commands as follows:
- All commands except REQUEST SENSE and INQUIRY return Check Condition status, while the format operation
is an active I/O process.
- When tagged queuing is enabled (DQue = 0), all commands except REQUEST SENSE and INQUIRY return
Queue Full status, while the FORMAT UNIT command is a queued I/O process.
- When tagged queuing is disabled (DQue = 1), all commands except REQUEST SENSE and INQUIRY return Busy
status, while the FORMAT UNIT command is a queued I/O process
- If a REQUEST SENSE command is received while a format operation is an active I/O process, the Target returns
Good status. The sense key is set to Not ready and the additional sense code and qualifier is set to Format In
Progress.
Progress.
- If an INQUIRY command is received while a format operation is an active I/O process, the Target returns Good
status and Inquiry data as requested.
The format operation must complete successfully for the Drive to be usable. If the command is interrupted by a reset,
power down, or an unrecoverable error, the Drive enters a degraded mode of operation in which reading and writing
are prohibited. To exit the degraded mode, another FORMAT UNIT command must be sent by the Initiator and com-
pleted successfully by the Target.
power down, or an unrecoverable error, the Drive enters a degraded mode of operation in which reading and writing
are prohibited. To exit the degraded mode, another FORMAT UNIT command must be sent by the Initiator and com-
pleted successfully by the Target.
The FORMAT UNIT command sets the Unit Attention Condition for all Initiators except the one that issued the FOR-
MAT UNIT command.
MAT UNIT command.