Manualsbrain.com
  1. Manuals
  2. Brands
  3. Adaptec
  4. 58300
  5. User Manual

Adaptec 58300 User Manual

Download
Page of 88
Appendix D: Using the AFU for DOS
●
75
Example
The following example shows a typical system response after a 
VERIFY
 command has been 
performed:
A:\> AFU VERIFY /C 0
Adaptec Flash Utility V1.0-0 B1406
(c)Adaptec Inc. 1999–2005. All Rights Reserved.
Reading flash image file (Build 1406)
Controller #0: Adaptec ASC-48300
File: Checksum: 642C [VALID] (Build 1406)
File: Checksum: 642C [VALID] (Build 1406)
Verified Successfully
VERSION
The 
VERSION
 command displays version information about the flash components on a 
HostRAID controller.
Command Syntax
The command syntax for the 
VERSION
 command is as follows:
AFU VERSION [/C<Controller ID>]
Command Switches
For details on the /C switch, see 
Example
The following example displays version information about all supported HostRAID 
controllers:
A:\> AFU VERSION /C 0
Adaptec Flash Utility V1.0-0 B1406
(c)Adaptec Inc. 1999–2005. All Rights Reserved.
Version Information for Controller #0 (Adaptec ASC-48300)
ROM: Build 1406 [VALID]
 
AFU Command Line – Step-by-Step
This section provides step-by step instructions for updating the flash. 
To update the flash using the AFU command line:
1
Shut down the computer.
2
Insert the bootable disk that contains the AFU utility.
3
Turn on the computer. 
4
Enter the system setup utility and verify that your computer is set up to boot from the 
bootable disk.