Addonics Technologies AEPUDDU User Manual

www.addonics.com

Technical Support (M-F 8:30am - 6:00pm PST)   

Phone: 408-453-6212 

Email: www.addonics.com/support/query/

Note: 

Plug and Play under Windows Me, 2000 and XP

 

Uses Mass Storage Driver under Windows Me, 

 

Windows 2000 and XP (Plug and Play)

1. 

Make sure your computer is up and running

2. 

Verify that all cables are connected.

3. 

Insert the Flash card that you will be using to the Digidrive.

4. 

Connect the USB cable to the USB Port.

5. 

A "New Hardware Found" message shall pops up. 

 

a. 

Follow the ON SCREEN wizard and point to the location of A:\USBWIN98 for the  

  driver.

 

b. 

Let Windows finish the installation and that’s it.

 

c. 

Double click My Computer icon and see if you have an extra drive letter for the  

 

 

Pocket Ultra Digidrive.

 

You may now access the Pocket Ultra Digidrive.

The pocket UDD is designed not to draw any power when there is no media inserted. So the LED light will 

remain off even the device is connected to the computer. 

Use the following procedures to add or remove the media from the Pocket UDD.

1. 

Insert the media fully into the device, the LED light will turn green, indicating the media is  

 

properly inserted inside and the device is now turned on. Your operating system will report new  

 

hardware detected and begin to install the device. This may take a few seconds before a new  

 

drive icon appears in the My Computer folder. During this initialization, the LED light on the  

 

Pocket UDD toggles between orange and green color; and will stay green once the computer  

 

recognizes the media.

2. 

Once the drive icon appears, the media is now ready and can be used like regular floppy  

 media.

3. 

During the read / write operation, the LED light of the Pocket UDD will turn Red.

4. 

To remove the media, click on the Safe Remove icon to stop the connection as shown below.  

 

Once the “you may now safely remove window” shows up, you can then remove the media  

 

from the Pocket UDD by pushing on the eject button. 

 

Note: if you eject the media from the Pocket UDD without checking the Safe Remove icon, a  

 

warning message will appear from Windows 98SE, Me and 2000. This message is a reminder  

 

that it is safer to use the Safe Remove icon when you remove the media to prevent possible  

 

data loss in case you are in the middle of copying a file to and from the media. You can go  

 

ahead and close this message.

5. 

After the media is ejected from the Pocket UDD, the LED light will go off, indicating the media  

 

is fully ejected from the device. 

6. 

Do not pull the media out of the device without using the eject button. This may crash the  

 

computer, as it does not realize the media has been manually removed from the device.